how to make white glue slime without activator

Now, you're probably thinking, slimekid, you said this was supposed to be clear slime, but my slime doesn't look clear! (You don't want to use detergent for this slime because it will get all cloudy.) You want to add less borax to the water if you are using borax as your activator or less baking soda to the glue if you are using contact/saline solution as your activator. Now add your activator SLOWLY until it starts to pull away from the bowl. Next, pour about half the amount of glue you added of water into the bowl and mix slowly (you always want to mix slowly when you're making clear slime so the least amount of bubbles form in the slime). So, to start with, pour your glue into the bowl. More activator makes it less sticky, but also less stretchy and more rubbery - so it will fall apart too easily. But don't add a lot! Add only one drop at a time, kneading after each until you have the consistency that you want your slime to be. If it's still sticky after you knead it for about a minute, then you can add more activator.

You only need a couple drops!Įven if it looks sticky to you, just stick your hands in and start kneading it. Then add in a tiny bit of your activator. Next add shaving foam (add approximately the same amount of shaving foam as glue). Add a couple pinches of baking soda, ONLY if you're using contact lens (saline) solution as your activator. The slime will end up being about twice the volume of the amount of glue you use (so use half as much glue as the amount of slime you want to end up with).

How to make white glue slime without activator